The first step in clearing ponds is to inspect the watershed and shoreline for signs of erosion. Grass sod should be established on bare areas. Rocks or other rip-rap material should be placed on shorelines of larger ponds if eroded by wave action.
Many ponds become temporarily muddy following heavy rains, but clearing usually occurs in a few days. Abundant bullhead catfish and/or common carp populations may also cause muddy conditions and should be eliminated.
If heavy rainfall or undesirable fish are not causing muddy conditions, the cause is negatively charged clay particles. These particles repel each other and will not settle out. The addition of positively charged particles causes coagulation and precipitation of clay particles.
Compounds recommended for clearing ponds include agricultural limestone, alum (aluminum sulfate) hydrated limestone and gypsum (calcium sulfate). The compound utilized should be determined by its cost, availability and effectiveness.
Ponds in East Texas require special consideration because of their typically low pH and total alkalinity. Water samples should be analyzed to determine the need for agricultural limestone applications. The addition of this compound often clears East Texas ponds.
Ponds in other areas of the state usually can be cleared with gypsum. However, tests should be run on each muddy pond to determine the type and amount of compound to use because conditions very greatly.
These tests can be run by obtaining several 1-gallon samples of pond water in glass jars. One of the gallon samples should be set aside as a control for comparison. A second gallon jug is needed to prepare a slurry for each compound tested. At least three other samples ahould be treated at various rates to determine the rate and type of compound that provides the most satisfactory results.
Number of tablespoons slurry added to 1 gallon pond water samples |
Rate of gypsum to apply to pond if sample clears in 12 hours (lbs/acre-foot) |
| 1 | 80 |
| 2 | 160 |
| 3 | 240 |
| 4 | 320 |
| 5 | 400 |
| 6 | 480 |
| 7 | 560 |
| 8 | 640 |
| 9 | 720 |
| 10 | 800 |
| 11 | 880 |
| 12 | 960 |
Number of tablespoons slurry added to 1 gallon pond water sample |
Rate of alum to apply to pond if sample clears in 12 hrs (lbs/acre-ft) |
For East Texas ponds*, also add hydrated lime at the rate of (lbs/acre-ft) |
For other ponds, also add hydrated lime at the rate of (lbs/acre-ft) |
| 1 | 30 | 13 | 0 |
| 2 | 60 | 26 | 0 |
| 3 | 90 | 39 | 13 |
| 4 | 120 | 52 | 17 |